Solved

2008 R2 server not booting

Posted on 2011-02-14
5
548 Views
Last Modified: 2012-06-27
Came in today and one of our DC's was done. Did not respond to power button so pulled plug and rebooted. Went thru its normal startup process and then asked if I wanted to start in safe mode or normal. First time choose normal the splash screen came up with the scrolling green bar then the screen went black and came up with text

xxx/xxxx (system files scrolling as the counter went up) it got to the end and then shut down again.

Anyone ever seen this before? If it matters its an HP proliant 320 G5
0
Comment
Question by:mrhamen
  • 3
5 Comments
 
LVL 7

Expert Comment

by:Cuteadder
Comment Utility
Any windows updates applied recently?
0
 
LVL 7

Author Comment

by:mrhamen
Comment Utility
No.
0
 
LVL 59

Expert Comment

by:Darius Ghassem
Comment Utility
Use the last known good option when you press F8
0
 
LVL 7

Accepted Solution

by:
mrhamen earned 0 total points
Comment Utility
Turns out it was the start of a hardware failure. System board ending up going south.
0
 
LVL 7

Author Closing Comment

by:mrhamen
Comment Utility
Ending up being a hardware failure issue that was starting.
0

Featured Post

Backup Your Microsoft Windows Server®

Backup all your Microsoft Windows Server – on-premises, in remote locations, in private and hybrid clouds. Your entire Windows Server will be backed up in one easy step with patented, block-level disk imaging. We achieve RTOs (recovery time objectives) as low as 15 seconds.

Join & Write a Comment

Normally after a failure of Domain Controller, when promoting new DC the DC is renamed, we will discuss the options in Dcpromo to re-create the DC with the same name. Scenario: You are a small IT shop with two Domain Controllers (Domain Contr…
We recently had an issue where out of nowhere, end users started indicating that their logins to our terminal server were just showing a "blank screen." After checking the usual suspects -- profiles, shell=explorer.exe in the registry, userinit.exe,…
This tutorial will give a short introduction and overview of Backup Exec 2012 and how to navigate and perform basic functions. Click on the Backup Exec button in the upper left corner. From here, are global settings for the application such as conne…
This tutorial will walk an individual through locating and launching the BEUtility application to properly change the service account username and\or password in situation where it may be necessary or where the password has been inadvertently change…

728 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question

Need Help in Real-Time?

Connect with top rated Experts

12 Experts available now in Live!

Get 1:1 Help Now