Solved

vpn client connection working using netscreen but not shrew vpn client

Posted on 2011-02-14
2
735 Views
Last Modified: 2012-05-11
As a test i have configured firewall using netscreen vpn client to connect and works, but when try using shrew vpn client  continuosly getting " gateway authentication error" . even though have same configuration working on a couple other boxes.



Thanks.


0
Comment
Question by:cisco20
2 Comments
 
LVL 4

Accepted Solution

by:
Allvirtual earned 500 total points
ID: 34891748
I am not familiar with Shrew. I would use the NCP client as the official replacement of the old NetScreen Remote client. It is much faster, stable, reliable, more features, better Technical Support,... in one word: The way to go. Check it out for a 30-day trial at http://www.ncp-e.com.
0
 

Author Closing Comment

by:cisco20
ID: 35027786
ncp was not an option.
0

Featured Post

Portable, direct connect server access

The ATEN CV211 connects a laptop directly to any server allowing you instant access to perform data maintenance and local operations, for quick troubleshooting, updating, service and repair.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

Suggested Solutions

Title # Comments Views Activity
anyconnect password change 2 38
SBS 2008 cannot logon remotely 7 62
MAC address learning of Riverbed 4 66
SSIS with VPN COnnection 2 101
This article is a step by step guide on how to create a basic PTP link using Ubiquiti airOS devices. This guide can be used on the following Ubiquiti AirMAX devices. Nanostation, Bullets, AirBridge, Nanobeam, NanoBridge to name a few. Please review …
This is an article about my experiences with remote access to my clients (so that I may serve them) and eventually to my home office system via Radmin Remote Control. I have been using remote access for over 10 years and have been improving my metho…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
Windows 10 is mostly good. However the one thing that annoys me is how many clicks you have to do to dial a VPN connection. You have to go to settings from the start menu, (2 clicks), Network and Internet (1 click), Click VPN (another click) then fi…

856 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question