Solved

Cicso wireless 1131g setup

Posted on 2011-02-15
3
889 Views
Last Modified: 2013-12-09
I ahve a Cisco Wireles  air 1131g-a-k9 that has no ethernet connections.  I have not used the cli for cisico in a while, but when i get into it through the console connection is says there is no default IP information in the system.  I have tried reseting this device numberouse times, but the ip information is not in it.  Can anyone give me the cli command to restore the default configuration to this device?
0
Comment
Question by:enary
  • 2
3 Comments
 
LVL 4

Assisted Solution

by:jhclemente
jhclemente earned 500 total points
ID: 34901705
if you have a line like  
   APname>
then type "enable" and it will ask you for your enable password, then it goes to
   APname#
then you type "configure terminal" and it'll go to:
   APname(config)#
then write   "erase start"
confirm hitting enter and then type "reload" and confirm again without saving changes.

The AP will reboot to factory defaults.... but even with that,I think this is DHCP configurable by default (maybe with fallback to 10.0.1.1)
0
 

Author Comment

by:enary
ID: 34901885
No sir, I have already done this.  The default ethernet ip is not reloading.  do you know the cli for reentering the ip address for it?  I am trying to find it in my manuals, but it has been a while since I took Cisco in School
0
 
LVL 4

Accepted Solution

by:
jhclemente earned 500 total points
ID: 34901929
As far as I remember... IP address by default is configured on BVI 1 interface...
Try this:

   # configure terminal
   (config)# interface bvi 1
   (config-if)#  ip address x.x.x.x 255.255.255.y
   (config-if)# end
   (config)#  write


0

Featured Post

Free camera licenses with purchase of My Cloud NAS

Milestone Arcus software is compatible with thousands of industry-leading cameras for added flexibility. Upon installation on your My Cloud NAS, you will receive two (2) camera licenses already enabled in the software. And for a limited time, get additional camera licenses FREE.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

With the purchase of CloudCommand by Comcast customers are left in a bind as subscriptions expire and render the AP's disabled. The following will explain how to flash your Ubiquiti AP's with CloudCommand firmware back to Ubiquiti firmware. HOWTO…
Multi-source agreements are important because they set standards that all manufacturers should follow to ensure that devices are compatible with multiple vendors. The multi-source agreement (MSA) is an agreement that establishes how multiple vendors…
This video shows syntax for various backup options while discussing how the different basic backup types work.  It explains how to take full backups, incremental level 0 backups, incremental level 1 backups in both differential and cumulative mode a…
Via a live example, show how to restore a database from backup after a simulated disk failure using RMAN.

895 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question

Need Help in Real-Time?

Connect with top rated Experts

14 Experts available now in Live!

Get 1:1 Help Now