Solved

Cisco 2621XM Hardware Compatibility Question

Posted on 2011-02-15
1
1,303 Views
Last Modified: 2012-06-27
I am extremely new to routers (other then home routers) and I have been trying to research some hardware compatibility for our Cisco 2621XM routers.

I know the 2621XM has 2 Fast Ethernet interfaces integrated already but I have a need for a third.  I have been trying to research compatible options but seem to running into conflicting information.  I have been looking at the following module, can someone let me know if this is compatible with the 2621XM and if so what the minimum IOS version required?  I am looking at the NM-1FE-TX.

If this module is not compatible can someone recommend a Fast Ethernet module that is compatible with the 2621XM?  I have both my WIC slots as well as the NM slot available in my configuration.

Thank you,
-David
0
Comment
Question by:admincbba
1 Comment
 
LVL 6

Accepted Solution

by:
wpharaon earned 250 total points
ID: 34903846
officially only the 3600 series routers support the NM-1FE-TX module, whereas the 2600XM routers only support the NM-1E and NM-4E modules.

however 2620XM and 2650XM's did run the NM-1FE-TX (unofficially)
0

Featured Post

On Demand Webinar - Networking for the Cloud Era

This webinar discusses:
-Common barriers companies experience when moving to the cloud
-How SD-WAN changes the way we look at networks
-Best practices customers should employ moving forward with cloud migration
-What happens behind the scenes of SteelConnect’s one-click button

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

While it is possible to put two routes in place with the secondary having a higher metric, this may not always work. In the event of a failure that does not bring down the physical interface on the router the primary route is not removed. There is a…
New Server 172.16.200.2  was moved from behind Router R2 f0/1 to behind router R1 int f/01 and has now address 172.16.100.2. But we want users still to be able to connected to it by old IP. How to do it ? We can used destination NAT (DNAT).  In DNAT…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…

680 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question