Solved

Cisco Aironet 350 Wireless Bridge

Posted on 2011-02-16
2
617 Views
Last Modified: 2013-12-09
Would anyone have any ideas on how to configure basic settings on a cisco Aironet 350 wireless bridge? I am replacing existing units (Cisco Aironet 340) however I am unable ot get into these units as I dont have the password.  If someone could point me towards some documentation etc that would be great
0
Comment
Question by:Jerzak1976
  • 2
2 Comments
 
LVL 45

Expert Comment

by:Craig Beck
ID: 34916284
Read the following doc... gives you full factory-reset procedures for Cisco Aironet products.

Its really easy for the 350 radios, but make sure you follow the correct procedure, as there is one for units with VxWorks software, and one for IOS.
0
 
LVL 45

Accepted Solution

by:
Craig Beck earned 250 total points
ID: 34916286
0

Featured Post

Scale it in WD Gold

With up to ten times the workload capacity of desktop drives, WD Gold hard drives employ advanced technology to deliver among the best in reliability, capacity, power efficiency and performance.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

Suggested Solutions

Title # Comments Views Activity
SSL RA VPN 7 102
Open a port on Cisco Router 1941 23 35
BGP Network restrictions 6 18
How can I measure the quality of my Internet access? 2 8
This subject  of securing wireless devices conjures up visions of your PC or mobile phone connecting to the Internet through some hotspot at Starbucks. But it is so much more than that. Let’s look at the facts: devices#sthash.eoFY7dic.
For Sennheiser, comfort, quality and security are high priority areas. This paper addresses the security of Bluetooth technology and the supplementary security that Sennheiser’s Contact Center and Office (CC&O) headsets provide.  
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…

937 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question

Need Help in Real-Time?

Connect with top rated Experts

5 Experts available now in Live!

Get 1:1 Help Now