• Status: Solved
  • Priority: Medium
  • Security: Public
  • Views: 402
  • Last Modified:

Multicast routing sparse mode

Can you give me an sample configuration to configure multicast routing in sparse mode on a HP 3500.  I have VLAN 10 for data and VLAN 172 for Video.  I am multicasting the video on address 226.16.149.2.  I can route between the VLANs without any issue.  
0
herbricords
Asked:
herbricords
1 Solution
 
Rick_O_ShayCommented:
I don't know the exact commands for the HP 3500 but in general on each router/L3 switch you need to enable PIM globally and on each routed IP interface you want it to cross. You also have to configure via a priority setting to make one router the BSR and the RP for the multicast groups you are using.

Something like this:
 interface vlan 3107
  ip address 10.16.1.50 255.255.255.248
  no ip proxy-arp
  ip pim sparse-mode
  no shutdown  
  exit
 ip pim bsr-candidate loopback 1 priority 250
 ip pim rp-candidate 10.16.1.234 224.0.0.0 240.0.0.0 priority 150
0
Question has a verified solution.

Are you are experiencing a similar issue? Get a personalized answer when you ask a related question.

Have a better answer? Share it in a comment.

Join & Write a Comment

Featured Post

Get Certified for a Job in Cybersecurity

Want an exciting career in an emerging field? Earn your MS in Cybersecurity and get certified in ethical hacking or computer forensic investigation. WGU’s MSCSIA degree program was designed to meet the most recent U.S. Department of Homeland Security (DHS) and NSA guidelines.  

Tackle projects and never again get stuck behind a technical roadblock.
Join Now