Solved

SonicWALL - How to Enable WAN HTTP Management?

Posted on 2011-02-20
3
946 Views
Last Modified: 2012-05-11
How do you set up a SonicWALL (TZ 180 with SonicROS Enahnced 4.2.1.0-20e) such that HTTP and HTTPS Management administration can occur over the WAN interface vs just the LAN and WLAN as per default?
0
Comment
Question by:gpsocs
  • 2
3 Comments
 
LVL 33

Accepted Solution

by:
digitap earned 500 total points
ID: 34939126
go to network then interfaces.  edit the wan interface and enable https management.  additionally, if you have any ports opened for http/https, then you'll want to change the default ports.  go to system then administration to change the default ports.
0
 

Author Closing Comment

by:gpsocs
ID: 34939574
Perfect.  Thanks!  I was attempting to add a new rule which never seemed to work! :)
0
 
LVL 33

Expert Comment

by:digitap
ID: 34939613
sure...thx for the pts!
0

Featured Post

Netscaler Common Configuration How To guides

If you use NetScaler you will want to see these guides. The NetScaler How To Guides show administrators how to get NetScaler up and configured by providing instructions for common scenarios and some not so common ones.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

Suggested Solutions

There are two basic ways to configure a static route for Cisco IOS devices. I've written this article to highlight a case study comparing the configuration of a static route using the next-hop IP and the configuration of a static route using an outg…
How to set-up an On Demand, IPSec, Site to SIte, VPN from a Draytek Vigor Router to a Cyberoam UTM Appliance. A concise guide to the settings required on both devices
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…

822 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question