How to add phone type analog to Cisco UCM 7?

I am trying to configure an FXS port to connect my fax machine.  I have a SIP trunk (supposedly T.38 climpiant) coming to the outside of my 2811 ISR and I have a couple of FXS ports on the 2811.  When I go to Device/Phone/Add...I don't see the option to add an Analog Phone.  What's the mojo??  Thank you.

Config on the ISR;

stcapp register capability 0/3/0 both
stcapp ccm-group 1
stcapp
voice-port 0/3/0
timeouts ringing infinity
description Fax 917-222-3131
caller-id enable
dial-peer voice 20 pots
description SCCP Controlled Analog FXS port
service stcapp


 Phone Types drop-down A Example Analog phone devices for FXS ports added by others earlier Example Analog phone devices for FXS ports added by others earlierScreenHunter-05-Feb.-21-10.16.gif
LVL 1
amigan_99Network EngineerAsked:
Who is Participating?
 
bfasonConnect With a Mentor Commented:
You will need to configure the Gateway. Look under gateway, select your router, then selecct your module for the appropriate slot, from here you can configure the line. See attached image

 FX0/FXS FX0/FXS
0
 
amigan_99Network EngineerAuthor Commented:
Thank you very much!
0
Question has a verified solution.

Are you are experiencing a similar issue? Get a personalized answer when you ask a related question.

Have a better answer? Share it in a comment.

All Courses

From novice to tech pro — start learning today.