Solved

non-cisco IP SUBNET-ZERO feature?

Posted on 2011-02-22
2
897 Views
Last Modified: 2012-06-22
do any other companies have enterprise routers that have something similar to cisco's IP SUBNET-ZERO?
0
Comment
Question by:insjbac
2 Comments
 
LVL 24

Accepted Solution

by:
rfc1180 earned 500 total points
ID: 34956169
Junipers, Adtran, Linux Routers, Brocade, Foundry, etc have it enabled in the code; The practice of avoiding subnet zero and the all-ones subnet eventually became obsolete with RFC1878; Cisco is the only vendor that I know of that has the commend 'ip subnet-zero'; also prior to Cisco IOS® Software Release 12.0, Cisco routers, by default, did not allow an IP address belonging to subnet zero to be configured on an interface, it is now enabled by default in the command with the option to disable it.

Billy
0
 

Author Closing Comment

by:insjbac
ID: 34961685
Excellent, would have been outstanding if it was easy to verify that the other vendors were able to use the first and last subnets in any particular subnetting scenario. but the RFC document shows first and alst subnets as being usable
0

Featured Post

Find Ransomware Secrets With All-Source Analysis

Ransomware has become a major concern for organizations; its prevalence has grown due to past successes achieved by threat actors. While each ransomware variant is different, we’ve seen some common tactics and trends used among the authors of the malware.

Join & Write a Comment

Creating an OSPF network that automatically (dynamically) reroutes network traffic over other connections to prevent network downtime.
If you're not part of the solution, you're part of the problem.   Tips on how to secure IoT devices, even the dumbest ones, so they can't be used as part of a DDoS botnet.  Use PRTG Network Monitor as one of the building blocks, to detect unusual…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…

707 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question

Need Help in Real-Time?

Connect with top rated Experts

16 Experts available now in Live!

Get 1:1 Help Now