Solved

dhcp not working

Posted on 2011-02-23
4
303 Views
Last Modified: 2012-05-11
Sometimes my dhcp server on my 3750 appears to stop working. When I try to run debug commands I get no output from the command. Any ideas?
0
Comment
Question by:glpro76
[X]
Welcome to Experts Exchange

Add your voice to the tech community where 5M+ people just like you are talking about what matters.

  • Help others & share knowledge
  • Earn cash & points
  • Learn & ask questions
  • 2
4 Comments
 
LVL 9

Expert Comment

by:ffleisma
ID: 34966199
can you give more details, if you can, could you show your configuration, probably a mis-configuration. cisco switches once configured properly won't give much problems. also, what debugs are you using?
0
 
LVL 15

Accepted Solution

by:
Ian Meredith earned 250 total points
ID: 34966656
0
 
LVL 9

Expert Comment

by:ffleisma
ID: 34967803
di you remove the ip helper address command under the interface vlan?
0
 
LVL 1

Author Closing Comment

by:glpro76
ID: 34993974
Thanks
0

Featured Post

Portable, direct connect server access

The ATEN CV211 connects a laptop directly to any server allowing you instant access to perform data maintenance and local operations, for quick troubleshooting, updating, service and repair.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

Arrow Electronics was searching for a KVM  (Keyboard/Video/Mouse) switch that could display on one single monitor the current status of all units being tested on the rack.
WARNING:   If you follow the instructions here, you will wipe out your VTP and VLAN configurations.  Make sure you have backed up your switch!!! I recently had some issues with a few low-end Cisco routers (RV325) and I opened a case with Cisco TA…
Michael from AdRem Software outlines event notifications and Automatic Corrective Actions in network monitoring. Automatic Corrective Actions are scripts, which can automatically run upon discovery of a certain undesirable condition in your network.…
Do you want to know how to make a graph with Microsoft Access? First, create a query with the data for the chart. Then make a blank form and add a chart control. This video also shows how to change what data is displayed on the graph as well as form…

729 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question