Solved

Cisco 877w - upgrading flash memory

Posted on 2011-03-01
3
812 Views
Last Modified: 2012-08-14
Hi,
I ordered a 16MB flash card for my 877w router. I found a manual on a Cisco website how to do it - looks very straightforward, but is there anything else I should do? Is going to work immediately after restarting the router? I backed up my config  and IOS...

Thx
0
Comment
Question by:m1979
3 Comments
 
LVL 34

Accepted Solution

by:
Istvan Kalmar earned 250 total points
ID: 35006105
0
 
LVL 3

Assisted Solution

by:macoronat
macoronat earned 250 total points
ID: 35008164
That's right, it should be very straight forward. Nothing to worry about.  After you install the new flash card, your router will prompt to ROMmon mode since it has no IOS in it.  Then just follow the instructions of the link that ikalmar posted.

Quick n easy :)
0
 

Author Comment

by:m1979
ID: 35009865
Thx guys!
0

Featured Post

PRTG Network Monitor: Intuitive Network Monitoring

Network Monitoring is essential to ensure that computer systems and network devices are running. Use PRTG to monitor LANs, servers, websites, applications and devices, bandwidth, virtual environments, remote systems, IoT, and many more. PRTG is easy to set up & use.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

Hello , This is a short article on how would you go about enabling traceoptions on a Juniper router . Traceoptions are similar to Cisco debug commands but these traceoptions are implemented in Juniper networks router . The following demonstr…
Tired of waiting for your show or movie to load?  Are buffering issues a constant problem with your internet connection?  Check this article out to see if these simple adjustments are the solution for you.
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…

840 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question