Solved

HP Procurve 5412 - OSPF - Default-information-originate command

Posted on 2011-03-01
2
1,817 Views
Last Modified: 2012-05-11
Hi.  Is it possible to use the 'Default-Information-Originate' command on a HP Procurve 5412 to broadcast a default route through OSPF?  if so, what is the minimum level of firmware that is required?

The information I have read so far is that it only seems to be available on the 9000 series routers.

Thanks
0
Comment
Question by:TheNumberUK
[X]
Welcome to Experts Exchange

Add your voice to the tech community where 5M+ people just like you are talking about what matters.

  • Help others & share knowledge
  • Earn cash & points
  • Learn & ask questions
  • 2
2 Comments
 
LVL 5

Accepted Solution

by:
roger_karam earned 500 total points
ID: 35011526
Hello, currently the default-information-originate command is not listed in the CLI or router guides. It is only supported 710x and 9000 series.

-RK
0
 
LVL 5

Expert Comment

by:roger_karam
ID: 35013555
0

Featured Post

Portable, direct connect server access

The ATEN CV211 connects a laptop directly to any server allowing you instant access to perform data maintenance and local operations, for quick troubleshooting, updating, service and repair.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

Suggested Solutions

We've been using the Cisco/Linksys RV042 for years as: - an internet Gateway - a site-to-site VPN device - a leased line site-to-site subnet-to-subnet interface (And, here I'm assuming that any RV0xx behaves the same way as an RV042.  So that's …
Shadow IT is coming out of the shadows as more businesses are choosing cloud-based applications. It is now a multi-cloud world for most organizations. Simultaneously, most businesses have yet to consolidate with one cloud provider or define an offic…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…

752 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question