Solved

pix 515e behind a netopia 3347

Posted on 2011-03-01
1
919 Views
Last Modified: 2012-05-11
I have a new dsl connection PPPoE and I need to configure my netopia 3347 to work with my pix 515e.   I thought I could put the netopia in bridge mode and then configure the pix to handle the internet connection but could not get it to work.    Is the local address on the netopia the same that I would use for my outside interface for my pix or would it be the peer address the netopia uses.  Is there a better way to do this than going in bridge mode?  Thanks in advance
0
Comment
Question by:rogue028
[X]
Welcome to Experts Exchange

Add your voice to the tech community where 5M+ people just like you are talking about what matters.

  • Help others & share knowledge
  • Earn cash & points
  • Learn & ask questions
1 Comment
 
LVL 5

Accepted Solution

by:
piwowarc earned 500 total points
ID: 35016769
Bridge mode might be your only recommended solution since you avoid double nating (netopia box) and then pix. In bridge mode netopia acts as a modem only. It is transparent. Your pix will get public IP.

Put netopia to bridge mode (page 109)

http://www.netopia.com/support/hardware/SoftwareUserGuideV761-Clsc.pdf

then confiugre pix to be a pppoe client (ommit pppoe server configuration)

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a00801055dd.shtml

HTH

Chris
0

Featured Post

Resolve Critical IT Incidents Fast

If your data, services or processes become compromised, your organization can suffer damage in just minutes and how fast you communicate during a major IT incident is everything. Learn how to immediately identify incidents & best practices to resolve them quickly and effectively.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

Suggested Solutions

Quality of Service (QoS) options are nearly endless when it comes to networks today. This article is merely one example of how it can be handled in a hub-n-spoke design using a 3-tier configuration.
How to set-up an On Demand, IPSec, Site to SIte, VPN from a Draytek Vigor Router to a Cyberoam UTM Appliance. A concise guide to the settings required on both devices
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
Both in life and business – not all partnerships are created equal. As the demand for cloud services increases, so do the number of self-proclaimed cloud partners. Asking the right questions up front in the partnership, will enable both parties …

752 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question