Solved

Linksys Login Issue

Posted on 2011-03-03
4
355 Views
Last Modified: 2012-05-11
Stupid problem I always run into.

I reset my linksys wireless routers. Have two WRT100, and WRT54Gl.

I can log in with default -blank/admin. I reset the password and save it.

Can never get back in. Maybe I am using the wrong username - admin, Admin, Administrator, administrator?

Help and tHanks SJMP
0
Comment
Question by:sparkis
  • 2
  • 2
4 Comments
 
LVL 8

Accepted Solution

by:
hunart earned 500 total points
ID: 35028626
The WRT100's default password is blank and the username is admin... while the WRT54G the username and password is admin.  Remember, it is case sensitive.

One other thing you should do... upgrade the firmware on these devices.
0
 

Author Comment

by:sparkis
ID: 35028948
I will upgrade the firmware and give that a shot.

If you dont mind me asking a related question about setup on WRT54G

Both of these routers are meant to give wireless access through our network. DHCP disabled
On the WRT100 I can set the WAN to Static - give it a LAN ip and internal DNS info so connected users can get internet access and they get DHCP from LAN.

But on the WRT54G it will not let me do this, since both LAN and WAN IP are on the same subnet.  Any idea how to fix this. It was working before I blew away the config.

Thanks,
0
 
LVL 8

Expert Comment

by:hunart
ID: 35084065
Are you OK with the WRT54G now?  Check the gateway setting on this router and make that it points to the same gateway as the WRT100.  You should work also check the DNS IPs again and make sure that they are correct.

Can you ping the DNS servers from the router?
0
 

Author Comment

by:sparkis
ID: 35084507
Yeah. I think I was just typing to fast. but did not have the problem post FW update.

Thanks,
0

Featured Post

PRTG Network Monitor: Intuitive Network Monitoring

Network Monitoring is essential to ensure that computer systems and network devices are running. Use PRTG to monitor LANs, servers, websites, applications and devices, bandwidth, virtual environments, remote systems, IoT, and many more. PRTG is easy to set up & use.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

Suggested Solutions

Title # Comments Views Activity
Cisco Router help 5 65
Some issue on SecurityCRT 5 32
cmd: can't connect using netsh command 14 90
Cisco 1811W VLAN configuration problem 3 29
There are two basic ways to configure a static route for Cisco IOS devices. I've written this article to highlight a case study comparing the configuration of a static route using the next-hop IP and the configuration of a static route using an outg…
Quality of Service (QoS) options are nearly endless when it comes to networks today. This article is merely one example of how it can be handled in a hub-n-spoke design using a 3-tier configuration.
This Micro Tutorial will show you how to maximize your wireless card to its maximum capability. This will be demonstrated using Intel(R) Centrino(R) Wireless-N 2230 wireless card on Windows 8 operating system.
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…

776 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question