Have a strange issue with a .kix logon script we are using. The script is supposed to map 6 network drives for users. Currently when users login it is basically skipping the "P" drive. You go into My Computer and it shows only 5 of the drives. I can manuallly map the same drive location so I know the network isn't down. Also, I have ran debugging on the script and on the lines of the script in question, it says the action completed successfully. Oddly enough, if I go into the script and change the drive letter to say "L", it shows up just fine when logging in, but as soon as you switch it back to "P" it disappears. The drive letter P is fully available and not being used by anything else.