joelahale
asked on
Exchange 2010 DAC Mode
What is the command to take the DAG out of DAC mode?
Set-DatabaseAvailabilityGr oup –identity “YOURDAGNAME” –DatacenterActivationMode Off DagOnly
ASKER
Should the DAG be in DAC mode all of the time or just during an outage?
Thanks
Please check below article from MS which explains in detail
http://technet.microsoft.com/en-us/library/dd979790.aspx
http://technet.microsoft.com/en-us/library/dd979790.aspx
This might point you to where DAC is required
http://www.howexchangeworks.com/2010/05/datacenter-activation-coordination-dac.html
http://www.howexchangeworks.com/2010/05/datacenter-activation-coordination-dac.html
ASKER
Thanks for articles.
I have read both
I must be overlooking the part regarding if DAC mode should be left on all of the time or only activated during an outage
Thanks again
I have read both
I must be overlooking the part regarding if DAC mode should be left on all of the time or only activated during an outage
Thanks again
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.