Basic config information for Cisco 5500 Wireless Controller

I recently received a Cisco 5500 Wireless Controller.

I am looking for basic configuration information on this device.

What would a basic running configuration consist of?

Any best practices to keep in mind when configuring these devices?

Open to suggestions. Thanks.
c-h-r-i-s-t-o-p-hAsked:
Who is Participating?
 
Craig BeckConnect With a Mentor Commented:
Look at this...
http://www.cisco.com/en/US/docs/wireless/controller/6.0/configuration/guide/c60pref.html

Its the configuration guide for V6 controller software.

You should also read this:
http://www.cisco.com/en/US/docs/wireless/technology/swan/deployment/guide/swandg.html


The basic configuration would consist of IP addressing for the management interface and AP-Manager interface, basic wireless settings (SSID, Regulatory domain, RF parameters), admin access and networking options (RADIUS, NTP, etc.).
0
 
c-h-r-i-s-t-o-p-hAuthor Commented:
Please note that I have several wireless vlans already in place on our infrastructure.

Our access points are running in stand-alone mode currently.
0
Question has a verified solution.

Are you are experiencing a similar issue? Get a personalized answer when you ask a related question.

Have a better answer? Share it in a comment.

All Courses

From novice to tech pro — start learning today.