Go Premium for a chance to win a PS4. Enter to Win

x
?
Solved

P2V conversion with vizioncore vConverter

Posted on 2011-03-09
4
Medium Priority
?
543 Views
Last Modified: 2012-05-11
Dear All,
I used the trial version of vconverter to evaluate the product.
I tried P2V task fron windows source to ESXI target and it worked fine (Hot mode).
I tried more than one time and it was OK.

Again i tried to use the continous protection type,the initial syncronization succeeded but the subsequent syncronization kept failing at the step of "Mounting Disk Image" it show the error "this may be caused by the loss of Network connectivity through conversion"

I kept monitoring The network,it is up i used the ping command and there was no packet loss.

I made sure that all requirments for Continous protection are applied.

After many trials I tried to convert the physical target again with Hot mode....I was surprised as I got the same error....It was working fine and I didnt change anything ???

Any advice?
0
Comment
Question by:mostabdo
  • 2
4 Comments
 
LVL 30

Expert Comment

by:pgm554
ID: 35090102
Why don't you use the Vmware P2V?

It's free and it works.
0
 
LVL 16

Expert Comment

by:Danny McDaniel
ID: 35091688
you might try hard setting the network speed and/or duplex on the source system and esxi hosts.
0
 

Accepted Solution

by:
mostabdo earned 0 total points
ID: 35092888
@pgm554 :I am not using vmware P2V as I need SW that can do P2V and V2P along with P2V incremintal Synchronization and vConverter should be able to do these.

@danm66: I will try this and let you know.
0
 

Author Closing Comment

by:mostabdo
ID: 36501219
I didnt got an answer from here but i knew from vizioncore that it is a bug.
0

Featured Post

How to Use the Help Bell

Need to boost the visibility of your question for solutions? Use the Experts Exchange Help Bell to confirm priority levels and contact subject-matter experts for question attention.  Check out this how-to article for more information.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

Here in this article, you will get a step by step guidance on how to restore an Exchange database to a recovery database. Get a brief on Recovery Database and how it can be used to restore Exchange database in this section!
Today as you open your Outlook, you witness an error message: “Outlook is using an old copy of your Outlook Data File…”. Probably, Outlook is accessing an old OST file.
Michael from AdRem Software explains how to view the most utilized and worst performing nodes in your network, by accessing the Top Charts view in NetCrunch network monitor (https://www.adremsoft.com/). Top Charts is a view in which you can set seve…
Whether it be Exchange Server Crash Issues, Dirty Shutdown Errors or Failed to mount error, Stellar Phoenix Mailbox Exchange Recovery has always got your back. With the help of its easy to understand user interface and 3 simple steps recovery proced…

782 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question