Solved

Associating New Cisco AP to New Cisco WLC

Posted on 2011-03-10
2
701 Views
Last Modified: 2012-05-11
We have a new wireless controller, and I am wondering what is involved in associating this new wlc with a new access-point.

Does the access point automatically detect the WLC or visa versa?

How do I go about pushing an initial config to the access point?
0
Comment
Question by:c-h-r-i-s-t-o-p-h
[X]
Welcome to Experts Exchange

Add your voice to the tech community where 5M+ people just like you are talking about what matters.

  • Help others & share knowledge
  • Earn cash & points
  • Learn & ask questions
2 Comments
 
LVL 24

Accepted Solution

by:
rfc1180 earned 500 total points
ID: 35099173
Honestly, you need to get down and dirty and get acquainted with the manual; involving a WLC and LWAP is a bit more complex in a autonomous system.

http://www.cisco.com/en/US/docs/wireless/controller/4.0/configuration/guide/ContCG40-Oct.pdf

>How do I go about pushing an initial config to the access point?
Is the AP a LWAP or an autonomous AP?

http://www.cisco.com/en/US/docs/wireless/controller/4.0/configuration/guide/c40wlan.html
http://www.cisco.com/en/US/docs/wireless/controller/4.0/configuration/guide/c40wlan.html
http://www.cisco.com/en/US/docs/wireless/controller/4.0/configuration/guide/c40lwap.html


Billy
0
 

Author Closing Comment

by:c-h-r-i-s-t-o-p-h
ID: 35110003
rats
0

Featured Post

Get your Conversational Ransomware Defense e‑book

This e-book gives you an insight into the ransomware threat and reviews the fundamentals of top-notch ransomware preparedness and recovery. To help you protect yourself and your organization. The initial infection may be inevitable, so the best protection is to be fully prepared.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

How to set-up an On Demand, IPSec, Site to SIte, VPN from a Draytek Vigor Router to a Cyberoam UTM Appliance. A concise guide to the settings required on both devices
WARNING:   If you follow the instructions here, you will wipe out your VTP and VLAN configurations.  Make sure you have backed up your switch!!! I recently had some issues with a few low-end Cisco routers (RV325) and I opened a case with Cisco TA…
Get a first impression of how PRTG looks and learn how it works.   This video is a short introduction to PRTG, as an initial overview or as a quick start for new PRTG users.
This video gives you a great overview about bandwidth monitoring with SNMP and WMI with our network monitoring solution PRTG Network Monitor (https://www.paessler.com/prtg). If you're looking for how to monitor bandwidth using netflow or packet s…
Suggested Courses
Course of the Month5 days, 23 hours left to enroll

627 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question