Solved

Cisco 871w access list

Posted on 2011-03-13
2
569 Views
Last Modified: 2012-05-11
I have a Cisco 871w. When I try to add ACL to open port 443, the permit statement goes after the implicit deny. This is the WAN port (FaEthernet) inbound access list 101. I have tried placing the statement in the backed up config file and then loading it back in to the running-config from tftp, but for some reason it will not load. I get a bunch of error. How can I manually add just this permit line above the implicit deny. Thank you!
0
Comment
Question by:ckleavitt2
2 Comments
 
LVL 24

Accepted Solution

by:
rfc1180 earned 500 total points
ID: 35123191
please post the output of show ip access-list 101

Typically you use the sequence numbers to add a list before or after a line.

http://www.cisco.com/en/US/docs/ios/12_2s/feature/guide/fsaclseq.html#wp1049152

Billy
0
 

Author Comment

by:ckleavitt2
ID: 35123741
Thanks. I found a solution elsewhere. But I ended up using the method you have suggested.
0

Featured Post

Free Tool: Path Explorer

An intuitive utility to help find the CSS path to UI elements on a webpage. These paths are used frequently in a variety of front-end development and QA automation tasks.

One of a set of tools we're offering as a way of saying thank you for being a part of the community.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

How to set-up an On Demand, IPSec, Site to SIte, VPN from a Draytek Vigor Router to a Cyberoam UTM Appliance. A concise guide to the settings required on both devices
Join Greg Farro and Ethan Banks from Packet Pushers (http://packetpushers.net/podcast/podcasts/pq-show-93-smart-network-monitoring-paessler-sponsored/) and Greg Ross from Paessler (https://www.paessler.com/prtg) for a discussion about smart network …
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…

821 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question