Solved

Nexus mgmt0 default gateway???

Posted on 2011-03-15
2
3,392 Views
Last Modified: 2012-06-27
I am setting up a Nexus 5548 running 5.0(2)N1(1).  I have setup a mgmt0 ip address but cannot figure out how to define the default gateway.  Our mgmt vlan traffic will only be on mgmt0.

I am not familiar with VFR, but I tried:

vfr context management
 0.0.0.0/0 10.C.B.A/22

and I cannot ping it, except directly connected.  

How is this done and where does Cisco document this?

Thanks,
0
Comment
Question by:ssol
2 Comments
 
LVL 50

Accepted Solution

by:
Don Johnston earned 500 total points
ID: 35142959
You're pretty close.

vrf context management
 0.0.0.0/0 10.C.B.A

Is the router at 10.C.B.A configured and working correctly?
0
 

Author Comment

by:ssol
ID: 35148093
donjohnston,

Yes, the router is config'd correctly.  I can ping the mgmt0 interface from the directly connected L2 switch and from the gateway router but it fails from other vlans.  Tcpdump shows the ICMP request go to the 5548, but no response.  

I think this is a vlan problem and not a default gateway problem.  Thank you.
0

Featured Post

PRTG Network Monitor: Intuitive Network Monitoring

Network Monitoring is essential to ensure that computer systems and network devices are running. Use PRTG to monitor LANs, servers, websites, applications and devices, bandwidth, virtual environments, remote systems, IoT, and many more. PRTG is easy to set up & use.

Join & Write a Comment

Suggested Solutions

I see many questions here on Experts Exchange regarding switch port configurations and trunks. This article is meant for beginners in the subject to help to get basic knowledge about Virtual Local Area Network (VLAN (http://en.wikipedia.org/wiki/Vir…
I eventually solved a perplexing problem setting up telnet for a new switch.  I installed a new Cisco WS-03560X-24P switch connected to an existing Cisco 4506 running a WS-X4013-10GE Sup II-Plus. After configuring vlans and trunking,  I could no…
In this seventh video of the Xpdf series, we discuss and demonstrate the PDFfonts utility, which lists all the fonts used in a PDF file. It does this via a command line interface, making it suitable for use in programs, scripts, batch files — any pl…
You have products, that come in variants and want to set different prices for them? Watch this micro tutorial that describes how to configure prices for Magento super attributes. Assigning simple products to configurable: We assigned simple products…

759 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question

Need Help in Real-Time?

Connect with top rated Experts

22 Experts available now in Live!

Get 1:1 Help Now