Solved

spanning port and monitoring

Posted on 2011-03-16
1
362 Views
Last Modified: 2012-05-11
I have spanned port that is set to capture only received traffic. But monitoring shows IN and OUT bandwidht etc.

is this to be expected? This is config i have for spanned port

monitor session 1 source interface Gi2/0/24 rx
monitor session 1 destination interface Gi2/0/7

show monitor session 1
Session 1
---------
Type                   : Local Session
Source Ports           :
    RX Only            : Gi2/0/24
Destination Ports      : Gi2/0/7
    Encapsulation      : Native
          Ingress      : Disabled

0
Comment
Question by:jly999
1 Comment
 
LVL 17

Accepted Solution

by:
MAG03 earned 500 total points
ID: 35146620
not quite sure if i understand your question correctly but the show command will always show the port being monitored and where the captured traffic is being sent to (destination).
0

Featured Post

Portable, direct connect server access

The ATEN CV211 connects a laptop directly to any server allowing you instant access to perform data maintenance and local operations, for quick troubleshooting, updating, service and repair.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

Suggested Solutions

Title # Comments Views Activity
IPv6 question 1 50
Multiple MPLS Circuits Connecting to LAN 3 58
BGP recommended setup with failover 2 85
Switch port problems 15 28
AWS has developed and created its highly available global infrastructure allowing users to deploy and manage their estates all across the world through the use of the following geographical components   RegionsAvailability ZonesEdge Locations  Wh…
Network ports are the threads that hold network communication together. They are an essential part of networking that can be easily ignore or misunderstood, my goals is to show those who don't have a strong network foundation how network ports opera…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
This video gives you a great overview about bandwidth monitoring with SNMP and WMI with our network monitoring solution PRTG Network Monitor (https://www.paessler.com/prtg). If you're looking for how to monitor bandwidth using netflow or packet s…

679 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question