Wireless Router or Access Point or Bridge

Here is what I would like to do .

At our main building we have an IP range of 192.168.0.x

At our DC location we have an IP rang of 192.168.2.x

I would like to set up a AP?/Wireless Router?/Bridge? so that the users at our DC location can connect wireless just like the wired PC's at the DC location can connect. (Using a 10/100 3Com hub and 2500 Cisco Router).

Michael HouserLan AdministratorAsked:
Who is Participating?
needleboyConnect With a Mentor Commented:
Did you plugged in AP to 3com hub?
If yes, check your IP, maybe is DHCP enabled on that AP and you have incorrect IP address.
Access the web interface and try to disable DHCP server on that AP.
Then you must get IP address from this subnet 192.168.2.x
Hi there,

You need Wireless AP.
Routers are used to segment the network.

Michael HouserLan AdministratorAuthor Commented:
I have just tried an AP with now luck. I can connect to it but  thats about all I can do
Michael HouserLan AdministratorAuthor Commented:
I Think it may be a network issue.

Yes the WET200 is plugged into the hub
Question has a verified solution.

Are you are experiencing a similar issue? Get a personalized answer when you ask a related question.

Have a better answer? Share it in a comment.

All Courses

From novice to tech pro — start learning today.