guitar_333
asked on
Cisco SDM 2.5 GUI Trouble
Hi all,
I am having trouble using Cisco SDM (on Cisco2821)...
When under SDM > Configure..
When I select 'Additional Tasks', nothing happens
I cannot seem to 'edit' anything.
When I select a firewall rule and click 'edit'....nothing happens
When I select a NAT rule and click 'edit' ...nothing happens
When I am at SDM > Monitor
All sections work except nothing happens when I click on Logging as well as Traffic Status
I have downgraded Java a few times from the latest to 6u23 and 6u19.
I even installed SDM on a different PC with the same results.
Any ideas?
I am having trouble using Cisco SDM (on Cisco2821)...
When under SDM > Configure..
When I select 'Additional Tasks', nothing happens
I cannot seem to 'edit' anything.
When I select a firewall rule and click 'edit'....nothing happens
When I select a NAT rule and click 'edit' ...nothing happens
When I am at SDM > Monitor
All sections work except nothing happens when I click on Logging as well as Traffic Status
I have downgraded Java a few times from the latest to 6u23 and 6u19.
I even installed SDM on a different PC with the same results.
Any ideas?
ASKER
I tried several versions of Java on two PC's....same results
(currently on 1.6.0_16)
I did upgrade from c2800nm-ipbase-mz.124-15.T 9 to c2800nm-advsecurityk9-mz.1 24-11.T today though
(currently on 1.6.0_16)
I did upgrade from c2800nm-ipbase-mz.124-15.T
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER
Thanks for the info on the CCP - Ill check it out!
After some googling earlier....it is confirmed I had to rollback to 6u11
After some googling earlier....it is confirmed I had to rollback to 6u11
Try, for example, this one:
http://www.oldapps.com/java.php?old_java=44