Solved

Route map issue on cisco routers

Posted on 2011-03-22
3
334 Views
Last Modified: 2012-05-11
Hi experts,

I have a odd situation,  have a cisco 1841 router which has a wic1-adsl card connected, currently my default route for all internet traffic isout of the dialer interface associated with the wic card.

However conenncted to one fa 0/0 is a connection to another subnet which has a 2801 router and another wic-1dsl card in which is used for ftp traffic.

What I want to do send all ftp traffic from the 1841 router across to the 2801 router and use that dsl but all other www traffic to go out of the local 18411841 router, so to recap everything to go out of the 1841 router except ftp traffic which.

I understand a route map is the answer but not sure.

I hope an expert can help

Thanks

Andy ..
0
Comment
Question by:webleyaxsor
  • 2
3 Comments
 
LVL 9

Accepted Solution

by:
ffleisma earned 500 total points
Comment Utility
!
ip access-list standard any_filter
 permit any
!
ip access-list extended ftp_filter
 permit tcp any eq ftp any
!
route-map ftp permit 10
 match ip address ftp_filter
 set ip next-hop 2.2.2.2
!
route-map ftp permit 20
 match ip address any_filter
!
!
interface FastEthernet0/0
 ip policy route-map ftp


next-hop of 2.2.2.2 is the `2801 ip address of the interface connected to router1

composed of three parts. ACL, route-map, policy on 1841 interface facing the internal LAN.

basically the route-map says that match ACL "ftp_filter" and point that to router2, anything else, let it be.

of coarse router1 and router2 has only default routes pointing to ISP. consider also running internal routing protocol, so as router 2 knows where to point to get to internal network.

hope this makes sense!
0
 

Author Comment

by:webleyaxsor
Comment Utility
Thanks I will be configuring it today, will let you knowhow I get on
andy ..
0
 

Author Closing Comment

by:webleyaxsor
Comment Utility
Hi, Thanks worked a treat, had to fiddle with the ftp-filter and bit , i had to add control and data 20 +21,

Andy
0

Featured Post

What Is Threat Intelligence?

Threat intelligence is often discussed, but rarely understood. Starting with a precise definition, along with clear business goals, is essential.

Join & Write a Comment

It happens many times that access list (ACL) have to be applied to outgoing router interface in order to limit some traffic.This article is about how to test ACL from the router which is not very intuitive for everyone. Below scenario shows simple s…
Tired of waiting for your show or movie to load?  Are buffering issues a constant problem with your internet connection?  Check this article out to see if these simple adjustments are the solution for you.
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…

771 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question

Need Help in Real-Time?

Connect with top rated Experts

11 Experts available now in Live!

Get 1:1 Help Now