?
Solved

machine with multiple IPs how to set source IP for certain traffic?

Posted on 2011-03-24
2
Medium Priority
?
267 Views
Last Modified: 2012-05-11
I have a question regarding routing and IP addressing on a host. I have a particular situation that I'm trying to resolve.

I have a partner company that has a very strange network setup in which requires us to use a secondary NAT address before our traffic leaves our system. Depending on what NAT address we send as our source, will depend if we have access to a resouce on the other end. Due to even more complexity there's situations that a certain NAT say 10.0.6.1 cannot talk all the hosts on the other side of the tunnel.

My question is this. If I assign two IPs to my NIC card say 10.0.0.1 (primary IP) and 10.0.0.2 (secondary IP) and I have a host that I'm communicating with such as 10.0.6.10. in order to get access to that host I need to send to 10.0.6.10 as 10.0.0.2 instead of 10.0.0.1 how would I accomplish this? I'm assuming I could somehow add a static route through windows but not sure how. Any ideas?


0
Comment
Question by:jbla9028
[X]
Welcome to Experts Exchange

Add your voice to the tech community where 5M+ people just like you are talking about what matters.

  • Help others & share knowledge
  • Earn cash & points
  • Learn & ask questions
2 Comments
 
LVL 1

Accepted Solution

by:
TheMammoth earned 2000 total points
ID: 35207147
You should be able to do a command prompt and something like:

route add 10.0.6.10 mask 255.255.255.255 10.0.0.2

See http://technet.microsoft.com/en-us/library/cc757323(WS.10).aspx

and then have a play...




0
 
LVL 1

Author Closing Comment

by:jbla9028
ID: 35366274
Thanks I will try this.
0

Featured Post

Independent Software Vendors: We Want Your Opinion

We value your feedback.

Take our survey and automatically be enter to win anyone of the following:
Yeti Cooler, Amazon eGift Card, and Movie eGift Card!

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

When it comes to security, there are always trade-offs between security and convenience/ease of administration. This article examines some of the main pros and cons of using key authentication vs password authentication for hosting an SFTP server.
WARNING:   If you follow the instructions here, you will wipe out your VTP and VLAN configurations.  Make sure you have backed up your switch!!! I recently had some issues with a few low-end Cisco routers (RV325) and I opened a case with Cisco TA…
In this video we outline the Physical Segments view of NetCrunch network monitor. By following this brief how-to video, you will be able to learn how NetCrunch visualizes your network, how granular is the information collected, as well as where to f…
Michael from AdRem Software explains how to view the most utilized and worst performing nodes in your network, by accessing the Top Charts view in NetCrunch network monitor (https://www.adremsoft.com/). Top Charts is a view in which you can set seve…
Suggested Courses

762 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question