Solved

Cisco ASA 5520 Config Example

Posted on 2011-03-25
1
1,161 Views
Last Modified: 2012-06-27
I am looking for an example Cisco ASA 5520 config that does the following:

DHCP relay
Failover

0
Comment
Question by:c-h-r-i-s-t-o-p-h
1 Comment
 
LVL 2

Accepted Solution

by:
leetpriest earned 500 total points
ID: 35218416
Failover config using management interface:

==================
Primary
==================

interface Management0/0
 description LAN Failover Interface
 no nameif
 no security-level
 

failover
failover lan unit primary
failover lan interface failover Management0/0
failover key <mykey>
failover interface ip failover 10.5.5.1 255.255.255.252 standby 10.5.5.2

================================================

secondary
================================================




interface Management0/0
 description LAN Failover Interface
 no nameif
 no security-level
 

failover
failover lan unit secondary
failover lan interface failover Management0/0
failover key <mykey>
failover interface ip failover 10.5.5.1 255.255.255.252 standby 10.5.5.2


Dhcp Relay:


dhcprelay <dhcp server ip address> <interface name>
dhcprelay enable <interface name>


0

Featured Post

PRTG Network Monitor: Intuitive Network Monitoring

Network Monitoring is essential to ensure that computer systems and network devices are running. Use PRTG to monitor LANs, servers, websites, applications and devices, bandwidth, virtual environments, remote systems, IoT, and many more. PRTG is easy to set up & use.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

Hello , This is a short article on how would you go about enabling traceoptions on a Juniper router . Traceoptions are similar to Cisco debug commands but these traceoptions are implemented in Juniper networks router . The following demonstr…
In the hope of saving someone else's sanity... About a year ago we bought a Cisco 1921 router with two ADSL/VDSL EHWIC cards to load balance local network traffic over the two broadband lines we have, but we couldn't get the routing to work consi…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…

860 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question