ICMP Best practice Configuration on ASA 5505 Firewall v.7.2 (4)

Greetings expert
I was looking for best practice concerning configuration of ICMP on ASA 5505 Firewall  v.7.2 (4)

Allowing Echo and Echo reply is clear enough, but what should also be added.

Can you also suggest where best to impletent through GUI. Fairly new with the product and not yet proficient with all the command lines.

As always your help is greatly appreciated!

C
CPropAsked:
Who is Participating?
 
Ernie BeekConnect With a Mentor ExpertCommented:
Normally:

access-list 101 permit icmp any any echo-reply
access-list 101 permit icmp any any source-quench
access-list 101 permit icmp any any unreachable  
access-list 101 permit icmp any any time-exceeded

Should be sufficient to make ping possible from the inside.

Source: http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_tech_note09186a0080094e8a.shtml
0
 
CPropAuthor Commented:
Would be nice to do it from GUI, but will get it done on CLI.

Thanks for your help!
0
 
Ernie BeekExpertCommented:
You're welcome :)
And well, a bit of CLI training is always good for you ;)

Thx for the points.
0
Question has a verified solution.

Are you are experiencing a similar issue? Get a personalized answer when you ask a related question.

Have a better answer? Share it in a comment.

All Courses

From novice to tech pro — start learning today.