Replacing Cisco 4506 with Cisco 4510R

Hi, all.

I am going to replace Cisco 4506 switch with Cisco 4510R and keep the same configuration.

All I need to do is backup the running config and restore to the new switch using TFTP or is there anything else involved?

Any feedback will be greatly appreciated.

Thanks.
LVL 12
InfamusAsked:
Who is Participating?
 
lrmooreCommented:
That's about it, but be aware that the port numbering will probably change. The SUP module goes into different slots on the 4510 and all the other module/port numbering will change.
0
 
shubhanshu_jaiswalCommented:
you can configure the new switch bit by bit...there may be many things which can be in different slots as Irmoore mentioned...
0
Question has a verified solution.

Are you are experiencing a similar issue? Get a personalized answer when you ask a related question.

Have a better answer? Share it in a comment.

All Courses

From novice to tech pro — start learning today.