3800 CISCO router and bonded t1s

Is it possible to bond six(6)  T1's and configure it as a Multilink interface in a 3845 router?

What would the router need as far as hardware and software/IOS version?


Who is Participating?
giltjrConnect With a Mentor Commented:
Yes, it possible, we had a ISP managed 3845 with 8 T1's bonded in a MPPP setup.

It had 8 T1 WIC V1 in it.

I don't have access to the config for that setup, but I think I can get one with 4 T1's.

I'm not 100% sure of the IOS level, it was 12.2 something.
Question has a verified solution.

Are you are experiencing a similar issue? Get a personalized answer when you ask a related question.

Have a better answer? Share it in a comment.

All Courses

From novice to tech pro — start learning today.