sheriftk
asked on
Unable to access Cisco UE GUI
Hi,
I'm unable to access the UE (Unity Express) interface thru web. Already confed the IP using the following statement.
interface Service-Engine1/0
ip unnumbered GigabitEthernet0/0
service-module ip address 10.0.0.10 255. 255. 255. 0
service-module ip default-gateway 10.0.0.1
!
ip route 10.0.0.10 255.255.255.255 Service-Engine1/0
I can ping both the router and service engine interfaces from the network.
Note: I'm basic on Cisco, though pretty good on *nix & General Telephony like Asterisk / Freeswitch. Just trying to cleanup an existing 38XX system which the vendor left. And thanks to Cisco making a rocket science out of a simple app like voicemail!!! A module talking to router via IP thru PCI & sitting in the same chassis running embedded Linux :) That too an IP alias...great.
I'm unable to access the UE (Unity Express) interface thru web. Already confed the IP using the following statement.
interface Service-Engine1/0
ip unnumbered GigabitEthernet0/0
service-module ip address 10.0.0.10 255. 255. 255. 0
service-module ip default-gateway 10.0.0.1
!
ip route 10.0.0.10 255.255.255.255 Service-Engine1/0
I can ping both the router and service engine interfaces from the network.
Note: I'm basic on Cisco, though pretty good on *nix & General Telephony like Asterisk / Freeswitch. Just trying to cleanup an existing 38XX system which the vendor left. And thanks to Cisco making a rocket science out of a simple app like voicemail!!! A module talking to router via IP thru PCI & sitting in the same chassis running embedded Linux :) That too an IP alias...great.
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER
I reset the module to factory defaults, then re initialised it.
Ok,
But you must enter above command for access Cisco UE GUI, without that you can't access
VIkrant
But you must enter above command for access Cisco UE GUI, without that you can't access
VIkrant
ASKER
yes, that was already configured, cuz i was able to access CME web.
ok
As you wish if you want to Delete this question
As you wish if you want to Delete this question
Vikrant