We help IT Professionals succeed at work.

Check out our new AWS podcast with Certified Expert, Phil Phillips! Listen to "How to Execute a Seamless AWS Migration" on EE or on your favorite podcast platform. Listen Now

x

Cisco dual T1 card on 2901 router

etude
etude asked
on
Medium Priority
934 Views
Last Modified: 2012-05-11
I have a 2901 router with a VWIC2-2MFT-T1/E1 card that I have not been able to make work.
I have added the following to my config but still don't have any serial interfaces available through IOS.
card type t1 0 0
controller T1 0/0/0
controller T1 0/0/1
Am I missing something or is this hardware combination just not supported?
Comment
Watch Question

SouljaSr.Net.Eng
CERTIFIED EXPERT
Top Expert 2011
Commented:
Unlock this solution and get a sample of our free trial.
(No credit card required)
UNLOCK SOLUTION
Unlock this solution and get a sample of our free trial.
(No credit card required)
UNLOCK SOLUTION

Author

Commented:
Thanks for the link, after reading the steps pretty carefully I found the that command I was missing was...
channel-group 1 timeslots 1-12

Open in new window

I am not really sure if I need/should use any of these other commands for a simple data T1 but so far I seem to be working after adding the above command to each controller.

Author

Commented:
Tahnks surbabu!!  I wish I had seen your post first, would have saved me about 15 minutes of reading :-)
SouljaSr.Net.Eng
CERTIFIED EXPERT
Top Expert 2011

Commented:
Lol. Sorry, I get lazy with typing commands in sometimes. Good to read up on things sometimes also.
Unlock the solution to this question.
Thanks for using Experts Exchange.

Please provide your email to receive a sample view!

*This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.

OR

Please enter a first name

Please enter a last name

8+ characters (letters, numbers, and a symbol)

By clicking, you agree to the Terms of Use and Privacy Policy.