• Status: Solved
  • Priority: Medium
  • Security: Public
  • Views: 936
  • Last Modified:

Can't setup WPA on Cisco 1200 AP when in workgroup bridge mode

When setting up Cisco 1200 AP's in workgroup mode I can only use no authentication or MAC authentication. Once I turn on any other authentication WEP, TKIP, etc. I immediately lose radio on the workgroup bridge.
1 Solution
Randy DownsOWNERCommented:

Featured Post

How to Use the Help Bell

Need to boost the visibility of your question for solutions? Use the Experts Exchange Help Bell to confirm priority levels and contact subject-matter experts for question attention.  Check out this how-to article for more information.

Tackle projects and never again get stuck behind a technical roadblock.
Join Now