James Coats
asked on
MS Access: Form controls, Option group
I know or at least think I am suppossed to use the Option Group Wizard to apply the control that would allow for one option button or the other option button to be selected but not both as in now the case with my form "frmNewToolDataEntry"
The wizard is in my tool box and seems to be active but when I try to select it nothing happens. Any suggestions?
Measuring-Instruments-3-4-26-11.mdb
The wizard is in my tool box and seems to be active but when I try to select it nothing happens. Any suggestions?
Measuring-Instruments-3-4-26-11.mdb
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER
Thanks again Capricorn1
ASKER
Capricorn1,
I don't see an "Option Group". I can see the "wand" with the 3 dots under it. I double click and nothing happens.
If I click on the "Option button" and then click on the wizard nothing still happens. Maybe my computer \ software is faulty or am I missing something still??
I don't see an "Option Group". I can see the "wand" with the 3 dots under it. I double click and nothing happens.
If I click on the "Option button" and then click on the wizard nothing still happens. Maybe my computer \ software is faulty or am I missing something still??
that is the image with a box and xyz label on top
-xyz-
| |
-----
-xyz-
| |
-----
ASKER
Cap,
That was so easy... thank you again!
That was so easy... thank you again!
try it with the Wizard selected