Hp Insight Diagnostics
Hp Insight Diagnostics
I wonder how you can tell which RAID configuration is applied to the physical drives.
For instance in HP, when using HP Insight manager to run HP Insight Diagnostic on a remote computer , all I see is the info such as:
Physical Hard Drive
and
Logical Disks
how can I tell what RAID is applied to the disks and if there is any disk left as a spare how can I tell that it is a spare.
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER
ASKER
the second set shows "Ready for rebuild" what does that mean?
Please upload the image again - it is corrupt.
ASKER
SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER
I haven't replaced any drive.
But wonder why it shows "Ready for recover".
In fact I walked over to the server, and noticed one of the drives has no lights on, neither amber nor green.
it s hard to tell, by just looking at it from outside, it could be a spare, it could be dead, etc...
but the ACU is showing " Ready for Recovery" what does that mean?
But wonder why it shows "Ready for recover".
In fact I walked over to the server, and noticed one of the drives has no lights on, neither amber nor green.
it s hard to tell, by just looking at it from outside, it could be a spare, it could be dead, etc...
but the ACU is showing " Ready for Recovery" what does that mean?
ASKER
thanks
ASKER
Array.jpg