• Status: Solved
  • Priority: Medium
  • Security: Public
  • Views: 1349
  • Last Modified:

Split graph of IPv4 and IPv6 on MRTG for Cisco 2960G

Hi,

Please refer diagram. I have a Cisco 2960G that I want to use to link all Routers A, B & C. I only have access on Cisco 2960G and not to any of the routers. All routers need to do BGP peering for both IPv4 and IPv6. Assuming I've configured Cisco 2960G as follows:

interface gig1/1
description Router A
switchport mode access
switchport access vlan 100
no shut

interface gig1/2
description Router B
switchport mode access
switchport access vlan 100
no shut

interface gig1/3
description Router C
switchport mode access
switchport access vlan 100
no shut

Is it possible to plot graph for both IPv4 and IPv6 traffic separately? Or do I need separate VLAN? If its possible, how do I do it?

Bur drawing
0
chainfear
Asked:
chainfear
  • 2
2 Solutions
 
gheistCommented:
router does not filter for snmp counter if it is ipx, arp, netbeui or whatever packet. it is physical frame count.
0
 
rfc1180Commented:
>Is it possible to plot graph for both IPv4 and IPv6 traffic separately? Or do I need separate VLAN? If its possible, how do I do it?

not with MRTG or any graphing application; you will need to utilize netflow:


http://www.cisco.com/en/US/docs/ios/fnetflow/configuration/guide/get_start_cfg_fnflow.html

Billy
0
 
chainfearAuthor Commented:
Hello All,

Sorry for my late reply.

So it is not possible without Netflow and if I just poll the port, I will only get all bandwidth and no way of getting separate graph of IPv4 and IPv6, is that correct?

Bur
0
 
rfc1180Commented:
Correct
0

Featured Post

Vote for the Most Valuable Expert

It’s time to recognize experts that go above and beyond with helpful solutions and engagement on site. Choose from the top experts in the Hall of Fame or on the right rail of your favorite topic page. Look for the blue “Nominate” button on their profile to vote.

  • 2
Tackle projects and never again get stuck behind a technical roadblock.
Join Now