New Exchange 2010 server will not receive mail

Hello,
I think I setup a receive connector on my new Exchange 2010 server, but it will not receive messages. I sent my account an email from gmail, and I received the following message:

The error that the other server returned was: 530 530 5.7.1 Client was not authenticated (state 13).

I have only done this once, and it was a couple years ago. How do I setup a receive connector on Exchange 2010 so that I can receive incoming messages? When i setup the exchnage server, I accepted the default, and all features are installed on one server.

Thanks,
John
LVL 1
jhiebAsked:
Who is Participating?
 
Shabarinath RamadasanConnect With a Mentor Infrastructure ArchitectCommented:
Seems some configuration issues with the connector you created.

Check this..
http://technet.microsoft.com/en-us/library/bb125159.aspx

And try if you can re-create based on the Microsoft guide.

Cheers
Shaba
0
 
jhiebAuthor Commented:
I forgot to allow anonymous messages. Thanks for the link. Here is the link I found:

http://smtp25.blogspot.com/2009/04/530-571-client-was-not-authenticated.html
0
 
ckeshavSr. Infrastructure SpecialistCommented:
How does the HUB server route the external mails(inbound and outbound) directly or through Edge Server or any other 3rd party Smart Host.

If you are using the Smart Host then you need to create a new Receive Connector for Relay and add the IP of the Smart Host in the new Receive connector

The below links should help you to create the new receive connector

http://technet.microsoft.com/en-us/library/bb232021.aspx
http://exchangeserverpro.com/how-to-configure-a-relay-connector-for-exchange-server-2010
0
Question has a verified solution.

Are you are experiencing a similar issue? Get a personalized answer when you ask a related question.

Have a better answer? Share it in a comment.

All Courses

From novice to tech pro — start learning today.