Changing ADSL settings in Cisco 877 from PPPoA to PPPoE

Muhajreen
Muhajreen used Ask the Experts™
on
Hello experts,

We have a Cisco 877. It was connected to an ADSL line with the following settings:

interface ATM0
 no ip address
 no atm ilmi-keepalive
 dsl operating-mode auto
!
interface ATM0.1 point-to-point
 pvc 8/35
  encapsulation aal5mux ppp dialer
  dialer pool-member 1
 !
!
interface Dialer0
 ip address negotiated
 ip nat outside
 no ip virtual-reassembly
 encapsulation ppp
 dialer pool 1
 dialer-group 1
 ppp authentication chap pap callin
 ppp chap hostname ######
 ppp chap password 0 #######
 ppp pap sent-username ####### password 0 #########

Now we will connect a new ADSL line to the Cisco 877 with the following new settings:

Encapsulation: PPPoE
VPI: 0
VCI: 33
Username: Newuser
Password: newpass
MTU Size: 1492

Would you please help writing the configuration chaning commands?
Comment
Watch Question

Do more with

Expert Office
EXPERT OFFICE® is a registered trademark of EXPERTS EXCHANGE®
System Administrator
Top Expert 2011
Commented:
by the way you can use SDM or Internet Explorer for your router configration, if you type your cisco router IP in internet explorer you will be able to do configration via GUI, but since you want CLI configration please find below;

interface ATM0
 no ip address
 no atm ilmi-keepalive
 dsl operating-mode auto


interface ATM0.1 point-to-point
 pvc 0/33
  pppoe-client dial-pool-number 1


interface Dialer0
 ip address negotiated
 ip mtu 1492
 ip nat outside
 ip virtual-reassembly
 encapsulation ppp
 dialer pool 1
 dialer-group 1
 no cdp enable
 ppp authentication chap pap callin
 ppp chap hostname XXXXXXXXXX
 ppp chap password 0 XXXXXXXX
 ppp pap sent-username XXXXXXXX password 0 XXXXXXXXX


ip classless
ip route 0.0.0.0 0.0.0.0 Dialer0

Do more with

Expert Office
Submit tech questions to Ask the Experts™ at any time to receive solutions, advice, and new ideas from leading industry professionals.

Start 7-Day Free Trial