ASA 5505 ROMMon

Phelms215 used Ask the Experts™

I have an ASA 5505 and when it boots up it goes to rommon for whatever reason, cant figure it out. when I type the boot command it goes right into the actual config and works beautifully. How do I make it boot by default?
Watch Question

Do more with

Expert Office
EXPERT OFFICE® is a registered trademark of EXPERTS EXCHANGE®
Sr. Systems Engineer
Top Expert 2008
Check "show ver" and look for the config register setting. It should be 0x1
Configuration register is 0x1

If it is anything else, set it to 0x1 from the config prompt
asa(config)#config register 0x1
ok! show us the output of show bootvar when u get into it!

Do more with

Expert Office
Submit tech questions to Ask the Experts™ at any time to receive solutions, advice, and new ideas from leading industry professionals.

Start 7-Day Free Trial