steps to configure bluecoat SG in inline mode

besmile4ever
besmile4ever used Ask the Experts™
on
Hi
dear I need the needed steps to configure the blue coat SG in inline mode

cheers
Comment
Watch Question

Do more with

Expert Office
EXPERT OFFICE® is a registered trademark of EXPERTS EXCHANGE®
Commented:
These are from the BC support page:-

Problem Description

You want set up an inline transparent proxy with a HW bridge.

You would also like to not have an IP associated with that bridge.

Resolution

To set up a proxy in a physically in-path deployment without an IP address on the bridge, you must meet these conditions:
 

    A management interface must be configured with an IP address. The proxy will use this IP address to perform various administrative tasks required for its operations on the network. For example, the proxy will use this IP address to do DNS lookups and reverse lookups depending on policies.
    The proxy must be deployed in such a way that it intercepts both outbound and inbound traffic in your network.

Then, ensure that the proxy is configured with the following settings:

    Set the bridge interface settings to FAIL_OPEN, so that the proxy can transparently bridge traffic in case of a failure.
    Enable reflect client IP so that the IP address of the proxy  isn't used as the source IP address.
    Enable trust destination IP to reduce the number of DNS lookups the proxy performs.

Author

Commented:
hi,
thnk you for your response.
what about if i want to use the software?
as i know i need only to set up the bridge for the 2 interfaces am i right?
is there any other settings i need.

Commented:
nope.

Author

Commented:
thnks.

Do more with

Expert Office
Submit tech questions to Ask the Experts™ at any time to receive solutions, advice, and new ideas from leading industry professionals.

Start 7-Day Free Trial