Avatar of 1stopit
1stopit
 asked on

Configuring second SIP trunk on Cisco UC500 series box.

We are trying to configure two SIP trunks on our UC540 system, one for inbound calling and one for outbound calling.  Our SIP trunk provider has assigned our ported office PSTN number on one SIP trunk, and we need the second trunk configured to take advantage of a specific billing feature.

Inbound calling is fine and is routed to a blast group - all good, but note we cannot configure the second trunk using the GUI and need to configure from the CLI... but need some help and guidance on what parameters we need to set.

Both SIP trunks are from the same provider, but two different platforms.  The inbound trunk is authenticated whereas the outbound is configured unauthenticated and is secured provider side by connecting IP address... so we just need to send direct to a server on provider side.

Both trunks are G.711a codec.

This is a multiple provider config, not a primary/secondary solution... if that makes any difference.

Thanks.
IP TelephonyVoice Over IP

Avatar of undefined
Last Comment
luc_roy

8/22/2022 - Mon
ASKER CERTIFIED SOLUTION
luc_roy

Log in or sign up to see answer
Become an EE member today7-DAY FREE TRIAL
Members can start a 7-Day Free trial then enjoy unlimited access to the platform
Sign up - Free for 7 days
or
Learn why we charge membership fees
We get it - no one likes a content blocker. Take one extra minute and find out why we block content.
Not exactly the question you had in mind?
Sign up for an EE membership and get your own personalized solution. With an EE membership, you can ask unlimited troubleshooting, research, or opinion questions.
ask a question
This is the best money I have ever spent. I cannot not tell you how many times these folks have saved my bacon. I learn so much from the contributors.
rwheeler23