WohlsenIT
asked on
Reset Admin Password for GUI
Recently some of our IT personel have left leaving us scramble for the passwords. The admin password to log into the Cisco firewall (GUI interface) does not appear to work. However, I can telnet into the firewall under the admin and make changes. Is there a way to reset the password with in the command line for the GUI interface?
Well normally the username/password should be the same. Are you using the same user for both logins?
ASKER
Yep, tried the admin log in via telnet, and also tried it on the GUI. For some reason the GUI doesn't allow me in.
If you try a blank username and the enable password?
ASKER
I tried both those as well with no luck. Is it possible to lock down the GUI by MAC address so that only one PC can access it coming in?
SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.