jskfan
asked on
display etherchannel bandwidth
Any way to display the aggregate bandwidth of an etherchannel?
for instance if 2 fastethernet are in the same channel group, I should see a bandwidth of 200 MB (100+100).
thanks
Switch1#sh etherchannel summary
Flags: D - down P - bundled in port-channel
I - stand-alone s - suspended
H - Hot-standby (LACP only)
R - Layer3 S - Layer2
U - in use f - failed to allocate aggregator
M - not in use, minimum links not met
u - unsuitable for bundling
w - waiting to be aggregated
d - default port
Number of channel-groups in use: 1
Number of aggregators: 1
Group Port-channel Protocol Ports
------+-------------+----- ------+--- ---------- ---------- ---------- ---------- ----
1 Po1(SU) - Fa0/11(P) Fa0/12(P)
for instance if 2 fastethernet are in the same channel group, I should see a bandwidth of 200 MB (100+100).
thanks
Switch1#sh etherchannel summary
Flags: D - down P - bundled in port-channel
I - stand-alone s - suspended
H - Hot-standby (LACP only)
R - Layer3 S - Layer2
U - in use f - failed to allocate aggregator
M - not in use, minimum links not met
u - unsuitable for bundling
w - waiting to be aggregated
d - default port
Number of channel-groups in use: 1
Number of aggregators: 1
Group Port-channel Protocol Ports
------+-------------+-----
1 Po1(SU) - Fa0/11(P) Fa0/12(P)
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER