Solved

ASA5510 command question

Posted on 2011-09-03
2
379 Views
Last Modified: 2012-05-12
Hello,
I need to know about these commands regarding the PIX and ASA:

Regarding the PIX command: sysopt connection permit-ipsec,
Was this command moved forward and used on the ASA5510?

Or was it replaced on the ASA5510 by this command: isakmp nat-traversal 20?

Thanks for your help!
0
Comment
Question by:mksmith58
2 Comments
 
LVL 18

Accepted Solution

by:
jmeggers earned 50 total points
Comment Utility
The command is not required in ASA configuration. I think it was essentially replaced by "isakmp permit <interface>" it's basically what turns IPSec on.
0
 

Author Closing Comment

by:mksmith58
Comment Utility
Thanks for clearing up its usage, you are correct in saying this is basically what turns on IPSec, however the syntax is "isakmp enable <interface>".  Thanks for your help.
0

Featured Post

Highfive Gives IT Their Time Back

Highfive is so simple that setting up every meeting room takes just minutes and every employee will be able to start or join a call from any room with ease. Never be called into a meeting just to get it started again. This is how video conferencing should work!

Join & Write a Comment

Overview Often, we set up VPN appliances where the connected clients are on a separate subnet and the company will have alternate internet connections and do not use this particular device as the gateway for certain servers or clients. In this case…
From Cisco ASA version 8.3, the Network Address Translation (NAT) configuration has been completely redesigned and it may be helpful to have the syntax configuration for both at a glance. You may as well want to read official Cisco published AS…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…

728 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question

Need Help in Real-Time?

Connect with top rated Experts

11 Experts available now in Live!

Get 1:1 Help Now