Solved

Cisco ATA CUCM configuration for faxing

Posted on 2011-09-06
4
1,055 Views
Last Modified: 2012-05-12
I've just purchased 2 new cisco ATA 187's and was a little confused on how to begin the install.

Do I set the ATA's up as phones under devices or as gateways in CUCM? These will be used specifically for faxing.  I would also like to ask if this setup would work through a VPN tunnel?

Any help is appreciated.
0
Comment
Question by:jwil320
  • 2
  • 2
4 Comments
 
LVL 18

Accepted Solution

by:
fgasimzade earned 250 total points
ID: 36491164
Set up ASA just like any other Ip phone, select it in the drop down list, enter MAC address, assign a number, etc
0
 
LVL 3

Author Comment

by:jwil320
ID: 36491199
Each ATA will have 2 lines associated to it correct?

So if I read correctly I will drop the first 2 hex digits and add 01 to the end for the 2nd line correct?
0
 
LVL 18

Expert Comment

by:fgasimzade
ID: 36491214
Yes, you are correct. You can connect 2 faxes, for example
0
 
LVL 3

Author Comment

by:jwil320
ID: 36491227
Thanks.
0

Featured Post

How your wiki can always stay up-to-date

Quip doubles as a “living” wiki and a project management tool that evolves with your organization. As you finish projects in Quip, the work remains, easily accessible to all team members, new and old.
- Increase transparency
- Onboard new hires faster
- Access from mobile/offline

Join & Write a Comment

This article will cover setting up redundant ISPs for outbound connectivity on an ASA 5510 (although the same should work on the 5520s and up as well).  It’s important to note that this covers outbound connectivity only.  The ASA does not have built…
This is an article about my experiences with remote access to my clients (so that I may serve them) and eventually to my home office system via Radmin Remote Control. I have been using remote access for over 10 years and have been improving my metho…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…

744 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question

Need Help in Real-Time?

Connect with top rated Experts

10 Experts available now in Live!

Get 1:1 Help Now