Solved

Multilink Frame Relay w/ QoS Conifguration Issue

Posted on 2011-09-13
4
332 Views
Last Modified: 2012-05-12
We are trying to bond two T1s on a Cisco 1841 router w/ 2 WIC cards.  It is a frame relay service.  I have read some Cisco articles but we are obviously missing somehting.  I was hoping someone could review the attached config we are trying to use and the error below as well and see where and or what we may doing wrong.
Thanks.

Boot Output Error:


frame-relay interface-dlci 26 IETF Virtual-Template1
                                   ^
% Invalid input detected at '^' marker.

  class QoS
   ^
% Invalid input detected at '^' marker.

frame-relay interface-dlci 26 IETF Virtual-Template2
                                   ^
% Invalid input detected at '^' marker.

  class QoS
   ^
% Invalid input detected at '^' marker.

1841samplemultilinkframeqos.txt
0
Comment
Question by:jtmoske
[X]
Welcome to Experts Exchange

Add your voice to the tech community where 5M+ people just like you are talking about what matters.

  • Help others & share knowledge
  • Earn cash & points
  • Learn & ask questions
  • 3
4 Comments
 
LVL 26

Expert Comment

by:Soulja
ID: 36531164
I don' t see:

frame-relay interface-dlci x ppp Virtual-Template1

under your serial interfaces.
0
 
LVL 26

Expert Comment

by:Soulja
ID: 36531185
Add bandwidth 3072 under the multilink interface also.
0
 

Author Comment

by:jtmoske
ID: 36543171
I see where those were missing.  The error message fooled me into thinking they were there.  
So I woudl apply VirutalTemplate1 to each serial interface individually correct?
0
 
LVL 26

Accepted Solution

by:
Soulja earned 500 total points
ID: 36543461
Add that command to both serials. You don't need the second virtual template.
0

Featured Post

Connect further...control easier

With the ATEN CE624, you can now enjoy a high-quality visual experience powered by HDBaseT technology and the convenience of a single Cat6 cable to transmit uncompressed video with zero latency and multi-streaming for dual-view applications where remote access is required.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

It happens many times that access list (ACL) have to be applied to outgoing router interface in order to limit some traffic.This article is about how to test ACL from the router which is not very intuitive for everyone. Below scenario shows simple s…
In the hope of saving someone else's sanity... About a year ago we bought a Cisco 1921 router with two ADSL/VDSL EHWIC cards to load balance local network traffic over the two broadband lines we have, but we couldn't get the routing to work consi…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…

734 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question