Solved

Optoma TX610ST flashing colors

Posted on 2011-09-14
1
356 Views
Last Modified: 2012-05-12
I have an Optoma TX610ST short throw projector that begins to flash red, blue, green after it warms up.  It looks as if it is going into a test mode, but I cannot stop it.  When you turn the projector off and when you turn it on again, it is fine until it is warmed up again.  The color flashing starts slow, then gets progressively faster.  It is not happening on the monitor of the computer, and when I disconnect the VGA cable from the back of the projector, the flashing continues.  Any ideas are appreciated! Thanks!
0
Comment
Question by:NewMilfordAdmin
1 Comment
 
LVL 69

Accepted Solution

by:
Callandor earned 500 total points
ID: 36537867
This is a DLP projector, which has a spinning color wheel in front of the bulb to generate colors.  It sounds like the syncrhronization of the wheel is off - you'll need to get it serviced, since that can't be fixed by users.
0

Featured Post

IT, Stop Being Called Into Every Meeting

Highfive is so simple that setting up every meeting room takes just minutes and every employee will be able to start or join a call from any room with ease. Never be called into a meeting just to get it started again. This is how video conferencing should work!

Join & Write a Comment

Is it worth it to buy an Echo? In a word, yes! For me it was definitely worth it. I use mine on a daily basis. Prologue & Privacy At first, I was very skeptical about the Amazon Echo. In general, I don't like voice assistants. I don't li…
The Rasberry PI is a low cost piece of hardware that you can have a lot of fun with through experimenting and building/working on projects like media players, running a low cost computer, build data loggers etc. - see: https://www.raspberrypi.org
This video gives you a great overview about bandwidth monitoring with SNMP and WMI with our network monitoring solution PRTG Network Monitor (https://www.paessler.com/prtg). If you're looking for how to monitor bandwidth using netflow or packet s…
This video shows how to remove a single email address from the Outlook 2010 Auto Suggestion memory. NOTE: For Outlook 2016 and 2013 perform the exact same steps. Open a new email: Click the New email button in Outlook. Start typing the address: …

707 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question

Need Help in Real-Time?

Connect with top rated Experts

13 Experts available now in Live!

Get 1:1 Help Now