• Status: Solved
  • Priority: Medium
  • Security: Public
  • Views: 420
  • Last Modified:

question about port-channels

I have a 6505 in vss. i have 2 links gi1/2/3, and gi2/2/3 on the 6505 that go back to my edge switch 3750e stack gi1/1/1, gi2/1/1 via fiber. I am about to create a port-channel on these links. Currently the EXISTING trunk link gi1/2/3 that connects to gi1/1/1 is configured for allowed vlan 26,78,82. Below is the config for the current 6505 and 3750 link. My question is when I create the port-channel on the 6505 and the 3750  do I remove the trunk configs from the connected gig interface(s) and add them to the port-channel interface(s)?

interface GigabitEthernet1/2/3 (on 6505)
 switchport
 switchport trunk encapsulation dot1q
 switchport trunk allowed vlan 26,78,82
 switchport mode trunk
 speed nonegotiate

interface GigabitEthernet1/1/1 (on 3750)
switchport trunk encapsulation dot1q
 switchport trunk allowed vlan 26,78,82
 switchport mode trunk
end
0
glpro76
Asked:
glpro76
1 Solution
 
SouljaCommented:
No, the config on all the interface including the port channel should be the same, except the gig interfaces will have channel group x mode x on them.


X denotes the port channel number and the type of etherchannel you select.
0
 
glpro76Author Commented:
Good enough for me. Thanks for the quick reply.  
0

Featured Post

Evaluating UTMs? Here's what you need to know!

Evaluating a UTM appliance and vendor can prove to be an overwhelming exercise.  How can you make sure that you're getting the security that your organization needs without breaking the bank? Check out our UTM Buyer's Guide for more information on what you should be looking for!

Tackle projects and never again get stuck behind a technical roadblock.
Join Now