Solved

how to setup port on Catalyst 2960G

Posted on 2011-09-15
2
309 Views
Last Modified: 2012-05-12
how do I make sure all ports on my Catalyst 2960G are enabled and set properly for – Auto/Auto, portfast.
0
Comment
Question by:Wazzume
2 Comments
 
LVL 27

Accepted Solution

by:
davorin earned 500 total points
ID: 36544760
0
 

Author Closing Comment

by:Wazzume
ID: 36544948
thanks
0

Featured Post

Enabling OSINT in Activity Based Intelligence

Activity based intelligence (ABI) requires access to all available sources of data. Recorded Future allows analysts to observe structured data on the open, deep, and dark web.

Join & Write a Comment

Suggested Solutions

It happens many times that access list (ACL) have to be applied to outgoing router interface in order to limit some traffic.This article is about how to test ACL from the router which is not very intuitive for everyone. Below scenario shows simple s…
The Cisco RV042 router is a popular small network interfacing device that is often used as an internet gateway. Network administrators need to get at the management interface to make settings, change passwords, etc. This access is generally done usi…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…

762 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question

Need Help in Real-Time?

Connect with top rated Experts

26 Experts available now in Live!

Get 1:1 Help Now