get catalyst switch to use RADIUS server

I just setup an NPS server on Windows server 2008. I have made a client on the NPS server that is for my Catalyst 4500 switch. However, how can I enable this switch so that it will send the users to the RADIUS server and use the policy I've made to allow only domain users/domain computers?
LVL 1
willlandymoreAsked:
Who is Participating?

[Webinar] Streamline your web hosting managementRegister Today

x
 
dsvodaConnect With a Mentor Commented:
radius-server host (enter ip of radius server)
radius-server key (enter key that you set on server)

to enable radius though is done through AAA, look at this section. Radius authentication and authorization
0
 
dsvodaCommented:
Please look into this article and see if it helps you.http://www.cisco.com/en/US/docs/ios/12_0/security/configuration/guide/scrad.html
0
 
willlandymoreAuthor Commented:
that looked really good, but there are no 'radius' commands for me that it was talking about. This is a 4507R-E routing switch.
0
All Courses

From novice to tech pro — start learning today.